QiyangProducts › OV5640 MIPI Camera Module

Qiyang Qiyang

OV5640 MIPI Camera Module

Posted 2019/01/30 08:47 AM by Qiyang views: 115

◆ Support output format including RAW, RGB565, YUV422, JPEG and so on.

◆ This module integrates oscillator, which could enable it to be used easily.

◆ QSXGA: 2592*1944 15FPS 1080P: 1920*1080 30FPS 720P:  1280*720 60FPS VGA: 640*480 90FPS QVGA: 320*240 120FPS

◆Optical size 1/4, pixel area 1.4 μm x 1.4 μm, sensitivity 600mV/Lux-sec

◆ Working voltage: 3.0V~5.5V

◆Support AF(Auto Focus), AE(Auto Exposure), AWB(Auto White Balance)

◆Interface Definition: 10*2, 2.54 spacing row needles 

ParameterSoftware FeaturesOrder InformationDownloads

Product Performance
MIPI low pressure differential serial port. Only the CLKP/N, DATAP/N signal,
two clock differential signals, and 2 pairs of differential data signals are required.
Obviously, the MIPI interface is less than the interface signal of DVP, because
it is a low-pressure differential signal, which has small interference and strong
anti-interference ability. The most important thing is that the DVP interface is restricted
in terms of signal integrity, and the rate is limited. Therefore, based on the stability
and simplicity of its design, the mipi interface is recommended.

Qiyang

Qiyang

Qiyang

Camera interface: Pin form(Perfect compatible to IAC_IMX6-MB_V1.2 development board)

Interfaces Pin Definition


VCC

3.3V are 5V both OK

GND

Connect to GND

CSI_DM/P

Camera MIPI data interface

CSI_CLKM/P

Camera MIPI data interface

I2C1_SDA

I2C data interface

I2C1_SCL

I2C clock interface

GPIO4_IO16

Connect to RESET

GPIO4_IO17

Connect to PWDN

GPIO4_IO19

Not connect by default